Sprocket Wheel Maintenance

May 28, 2020 Leave a message

  As a new gear product, sprocket has a high transmission speed. In its specific application, sprocket has the advantage of high rotating speed, resulting in very little noise, which is also conducive to the realization of a good processing environment. Sprocket in its application not only the installation of high precision, and the processing precision is also very ideal, which for the future maintenance work can be saved a lot of trouble. And sprocket structure compact advantage makes it has a larger transmission ratio, and its service life is relatively high.

  1, the tightness of the sprocket should be appropriate, too tight will increase the power consumption, bearing easy to wear; Too loose sprocket easy to jump and off the chain. The degree of tightness of the sprocket is: from the middle of the sprocket to lift or press down, about two sprocket center distance of 2-3%.

  2, sprocket installed on the shaft should not swing and tilt. In the same transmission component, the end faces of two sprockets should be located in the same plane. When the sprocket center distance is less than 0.5 meters, the deviation can be 1 mm. Sprocket center distance in 0.5 meters above, can be deviation of 2 mm. But there can be no friction sprocket tooth side phenomenon, if the two wheels offset too much easy to produce off the chain and accelerated wear. The offset must be checked and adjusted when replacing the sprocket.

  3. Replace the new sprocket and new sprocket at the same time after the sprocket is badly worn to ensure good engagement. You can't just replace a new sprocket or a new sprocket. Otherwise, it will cause bad meshing to accelerate the new sprocket wheel or wear of the new sprocket wheel. Sprocket tooth surface wear to a certain extent should be turned in time after use (refers to the adjustable surface used sprocket), in order to extend the use time.

  4, the new sprocket is too long or after use elongation, it is difficult to adjust, you can see the case to remove the chain, but must be even. The link shall pass through the back of the sprocket, and the locking plate shall be inserted outside. The opening of the locking plate shall be in the opposite direction of rotation.

  5, sprocket in the work should be timely filled with lubricating oil. The lubricating oil must go into the matching gap between the roller and inner sleeve to improve working conditions and reduce wear.

  6. Old sprocket cannot be mixed with part of new sprocket, otherwise it is easy to produce impact in the transmission and break the sprocket.

  7. When the machine is stored for a long time, the sprocket should be removed and cleaned with kerosene or diesel oil, then coated with oil or butter and stored in a dry place.